Silicone Adhesives  -   electrically conductive

1-component Adhesives

The following 1-component adhesives cure quickly at room temperature. When fully cured, they remain as elastic as rubber and are homogenous conductive. In addition, they distinguish themselves by an especially high level of heat conductivity.

The material properties for individual applications are listed in the table below.

NEUSIL™
Material description

1 - component	NEUSIL	K580	K682	K684
elastomer binder		silicone	silicone	silicone
conductive particles		Ni	Ag / Cu	Ag
density DIN 53479	g/cm³	2,0	2,4	3,0
Shore-A hardness DIN 53505	± 6	59	62	60
volume resistance VDE 0303	Ohm cm	0,9	0,08	0,005
temperature range	°C	- 55 / +200	-55 / +125	-55 / +200
elongation at break DIN 53504-S1	%	> 45	> 35	> 40
colour		black	beige	beige
shielding effectiveness dB:
H-field 10 KHz		70	67	69
E-field   1 MHz		110	130	130
P-field   1 GHz		88	110	110
conductive adhesives:
metal with metal		good	good	good
metal with RFI gasket		good	good	good
RFI gasket with RFI gasket		good	good	good
adhesion on aluminium	N/cm	> 18	> 18	> 18
removable back with NEU-LöS 12		no	no	no
viscosity upon delivery	21 °C	viscous	viscous	viscous
solvent toluene	%	5	5	5
catalyst air humidity	21 °C	yes	yes	yes
curing rubber-elastic		yes	yes	yes
film formation at 0,2 mm strength	Minute	1 - 2	1 - 4	1 - 3
curing at 0,2 mm strength	Minute	4 - 100	5 - 20	5 - 20
curing based on film strength and venting surface approx.	Minute	100 - 300	3 - 180	3 - 180
odourless curing		no	no	no
resistance against	UV,ozone	yes	yes	yes
storage time:
plastic cartridges	month	0,5	0,5	0,5
aluminium cartridges	month	3	3	3
1 - component	NEUSIL	K580	K682	K684
d o w n l o a d
technical data sheet  ➽
processing instructions  ➽
safety data sheet  ➽